Komatsu — Replace Slow-Blow Fuse

Replace Slow-Blow Fuse MAINTENANCE Remark Always turn the power OFF when replacing the slow-blow fuse (turn the starting switch to the OFF position). If machine is equipped with a battery disconnect switch, turn switch to turn off power to machine and take key out also. Always replace the slow-blow fuse with one of the same capacity. The slow-blow fuses (1), (2), (3), (4), (5) are located in a fuse box at the left side of the machine, at the side of the engine. 1. Turn the starting switch to the OFF position (A). 2. Remove the slow-blow fuse box from the chassis. 3. Open covers (1), (2), and (3) of the slow-blow fuse box.

Covers (2) and (3) can be removed easily by using protrusion (A) on the body as a fulcrum and levering the catch of the cover with a flat-headed screwdriver to release it. 4. Loosen screws (4) and (5) and remove them. When screws (4) and (5) are removed, slow-blow fuse (6) will also come off, together with electric wiring (7) and (8). 5. Using screws (4) and (5), install a new slow-blow fuse together with electric wiring (7) and (8) in the slow-blow fuse box; then close covers (1), (2), and (3). 6. Install the slow-blow fuse box to the chassis.

WA430-6 3-51 (1) 50A Permanent power source (2) 50A Main power A (3) 50A Main power B (4) 120A Charging circuit (5) 120A Heater relay (electrical air intake heater)