Check Air Conditioner Compressor Belt Tension, Adjust MAINTENANCE Checking 1. Stop the engine. 2. Remove cover (1). Belt deflection should be 11 to 15 mm (0.43 to 0.59 in) when pressed with a finger force of approximately 98 N (22.03 lbf) at a point midway between the air conditioner compressor pulley and the crank pulley. When a belt tension gauge is used, the standard tension is within a range of 353 – 530 N (79.36 – 119.15 lbf). Check When Changing the V-Belt Belt deflection should be 8 to 11.5 mm (0.31 to 0.45 in) when pressed with a finger force of approximately 98 N (22.03 lbf) at a point midway between the air conditioner compressor pulley and the fan pulley.
When a belt tension gauge is used, the standard tension is within a range of 530 – 745 N (119.15 – 167.48 lbf). Remark When the belt has been replaced with a new part, a high tension is necessary. The initial tension is the value given above. Adjusting 1. Loosen bolt (1), then loosen the locknut of bolt (2). 2. Tighten bolt (2) and move compressor (3) to adjust. 3. Tighten bolt (1) and the locknut of bolt (2) to hold compressor (3) in position. 4. Check each pulley for damage, wear of the V-groove, and wear of the V-belt. In particular, be sure to check that the V-belt is not touching the bottom of the V-groove. 5.
If the fan belt exhibits any of the following problems, ask the Komatsu distributor in your territory to replace the belts with new ones: The fan belt has elongated, leaving little allowance for adjustment. There is a cut or crack on the belt. A slipping or creaking sound is heard from the belt. 6. When the V-belt is set, operate the machine for one hour and then adjust the belt again. WA430-6 3-63