Check Function of Brake Accumulator MAINTENANCE For details of handling the accumulator, see Section “Accumulator and Gas Spring” on page 1-50. If the engine stops when the machine is traveling, the oil pressure in the accumulator can be used to apply the brake as an emergency measure. 1. Stop the machine on level ground and lower the work equipment completely to the ground. 2. Set the parking brake to the ON position (A). 3. Start the engine; run it at a mid-range speed for one minute; then stop the engine. 4. Turn the starting switch key to the ON position (B) and depress the brake pedal repeatedly.
If the brake oil pressure caution lamp does not light up even when the brake is depressed six times, the gas pressure in the accumulator is normal. If the brake oil pressure caution lamp lights up when the brake has been depressed five or less times, the gas pressure in the accumulator has probably dropped. Contact your Komatsu distributor to have the accumulator inspected. Remark Carry out the check within five minutes after stopping the engine. If the machine is left with the engine stopped, the accumulator pressure will drop and it will be impossible to check the cause of the problem. WA430-6 3-65