Komatsu — Precautions for Steering with Joystick

OPTIONS, ATTACHMENTS Precautions for Steering with Joystick If using the joystick lever to operate the steering and transmission but the operation of the machine does not match the operation performed by the operator and the warning lamp lights up, do these steps. Use the steering wheel to steer, if necessary; apply the brakes immediately; turn the joystick ON/OFF switch OFF; operate the steering wheel and the directional lever to move the machine to a safe place; then stop the machine. Before starting the operation of the machine again, find the problem part and repair it then confirm that the function is normal. For troubleshooting and repair, contact your Komatsu distributor.

Never operate the machine before it is repaired completely. If the machine is steered with the steering wheel, its turning angle is fixed when turning of the steering wheel stops. If the machine is steered with the joystick and the joystick is held in a turning position, the machine is steered to the articulate end. Since the feel of steering with the joystick is different from using the steering wheel, be very careful until you are accustomed to the joystick.

If the joystick ON/OFF switch is turned OFF and the directional selector switch and directional lever are not at the N position, the neutral interlock circuit is actuated; the central warning lamp lights up; and the alarm buzzer sounds. Return the directional selector switch and directional lever to the N position. If there is a problem with the electric circuit of the joystick steering system or transmission control system, the central caution lamp (red) on the left side of the machine monitor flashes to notify the operator of the problem.

Since both steering system and transmission are set in the respective neutral positions, turn off the joystick ON/OFF switch, then use the steering wheel and the directional lever to drive the machine. 5-8 WA430-6