PACCAR 520 — How to Recover a Vehicle

EMERGENCY - How to Recover a Vehicle is stopped. You could seriously damage your vehicle by towing it with the driveline connected and the drive wheels on the ground. Worse, when vehicles are towed, either by wrecker or piggyback, the lubricant in the top front of the drive axle will drain to the rear. This will leave the top components dry. The resulting friction may damage them. Always remove the main drive axle shafts before towing your vehicle. How to Recover a Vehicle CAUTION Follow these steps to properly recover a vehicle from a situation where the vehicle is unable to move on its own. Connect recovery rigging only to hitches in- tended for that purpose.

Do not attach to bumpers or brackets. Use only equipment designed for this purpose. Failure to comply may result in equipment damage. 2 CAUTION WARNING! Remove the drive axle shafts or lift the driv- ing wheels off the ground before towing the vehicle. Towing the vehicle with either the wheels on the ground or the axle shafts in the axles will cause damage to the axle gears. Before towing a vehicle, test your air brakes to ensure that you have properly connected and inspected the recovery vehicle’s brake system. Failure to do so could lead to a loss of vehicle control which may result in an ac- cident involving death or personal injury. 1.

Review and understand all the cautions and warnings of this section. 2. Install the recovery hitch. See What is a Recovery Hitch? on page 40 and How to use a Recovery Hitch on page 41. 3. Disconnect the drive axle shafts and cover the open hubs. This is necessary because if the transmission is driven by the driveshaft (rear wheels on the ground), no lubricant will reach the gears and bearings, causing damage to the transmission. See How to Prepare the Axles for Towing on page 41. 4. Install the recovery rigging using a safety chain system, See What are CAUTION Your vehicle is equipped with removable Recovery Hitches, designed for short distance recovery purposes only.

Use only the provided hitches, according the following instructions. When using this connection, do not transport your vehicle over long distances. (If your vehicle does not have the proper hitches, contact your dealer.) If your vehicle has a Meritor axle with a driv- er-controlled main differential lock, install the caging bolt before removing the axles for towing, see Driver Controlled Main Differ- ential Lock. Installing the caging bolt pre- vents damage by locking internal axle com- ponents in position. All lubricating and clutch application oil pressure is provided by an engine-driven pump, which will not work when the engine Y53-6096-1A1 (01/17) 37