How to Procedures 4. Install the prefilter into the fuel filter module. 5. Turn the cap counterclockwise until a click sound is made, then turn clockwise and hand-tighten. 6. Torque prefilter cap to 55 to 60 N·m (41 to 44 ft·lb). 7. Once all required filters have been changed, prime the fuel system. Refer to section "Priming the Fuel System - KM63 GEN2 - Two-Filter System" Refer to section "Priming the Fuel System - KM59 GEN1 - Two-Filter System" Removal of the Water Coalescer/Final Filter - Two-Filter System Remove the water coalescer/final filter as follows: NOTICE: Do not tilt the water coalescer/final filter when removing it from the housing.
Possible damage to the water coalescer/final filter or stand pipe may occur. 1. Using a 36mm socket, unscrew the water coalescer/final filter cap. 2. Pull the cap and water coalescer/final filter straight up and allow the fuel to drain back. 3. Remove the water coalescer/final filter (2) from the water coalescer/final filter cap (1) by placing the filter on a solid surface with the drain back plug location at 12 o’clock (3) and apply pressure on the water coalescer/final filter cap at an angle. 100 All information subject to change without notice. Copyright © 2019 DETROIT DIESEL CORPORATION DDC-SVC-MAN-0209