MAN — Monitoring the Engine Operation

Operating Instructions for Starting the Engine Checking the Coolant Level (Hot Check) Check the coolant levels as follows: 1. Allow the engine to run for approximately five minutes at a moderate speed. 2. After the coolant temperature reaches 50°C (122°F), recheck the coolant level in the surge tank. WARNING: HOT COOLANT To avoid scalding from the expulsion of hot coolant, never remove the cooling system pressure cap while the engine is at operating temperature. Wear adequate protective clothing (face shield, rubber gloves, apron, and boots). Remove the cap slowly to relieve pressure. 3. Add more coolant if necessary. Open the heater valves before adding coolant. 4.

Do not close the heater valves until the engine has been running briefly and the coolant level is again checked and corrected as necessary. Monitoring the Engine Operation While the engine is operating, monitor the battery charge indicator light and the oil pressure. Excessive idling should be avoided. Monitoring the Battery Charging System The battery charge indicator light must go out once the engine starts. If the indicator light comes on while the engine is running, do the following: 1. Shut down the engine. 2. Test the charging system, per OEM guidelines. WARNING:

BATTERY EXPLOSION To avoid injury from battery explosion when jump starting the engine, do not attach the cable end to the negative terminal of the disabled battery. 3. If necessary, visit the nearest authorized dealer to have the alternator voltage and output checked. 4. Do a load test on the batteries. 5. Replace components as needed. 34 All information subject to change without notice. Copyright © 2019 DETROIT DIESEL CORPORATION DDC-SVC-MAN-0209