DD Platform EuroV Operators Manual How to Replace the Lubricating Oil and Oil Filter The oil filter is an integral part of the lubrication system. Proper filter selection and maintenance are important to satisfactory engine performance and service life. The filter should be used to maintain a clean system, not to clean up a contaminated system. The maintenance intervals for the appropriate duty cycle are listed in tables in this manual. Change the oil and replace the lubricating oil filter as follows: NOTE: If the used oil was contaminated by fuel or coolant, it may be necessary to take the vehicle to a certified Detroit Service Center.
The Service Center may drain the oil and then remove the oil pan, oil pump, and oil pump intake manifold to drain the remaining oil held back by the backflow valve. It is important to remove all contaminated oil from the engine. NOTE: Change the engine oil only when the engine oil temperature is approximately 60°C (140°F). Changing cold oil will result in extended drain times. WARNING: PERSONAL INJURY To avoid injury, never remove any engine component while the engine is running. 1. Place the transmission in neutral, and set the parking brake. NOTICE: Use care to prevent foreign objects from entering the filter housing. 2. Clean outside of the oil filter housing. NOTICE:
On some chassis models the air filter housing may interfere with removing the oil filter cap and filter element straight up. If this is the case, loosen or remove the air filter housing to allow for proper oil filter removal. Removing the filter element on an angle may damage the oil filter standpipe or bypass valve. 3. Using a 36-mm socket, unscrew the oil filter cap and filter and allow the oil to drain into the housing. After draining is complete, remove the assembly from the housing. 4. Remove the filter element by pressing and twisting the side and detaching it from the cap. 5. Remove the oil filter cap O-ring and discard.
Lightly coat a new O-ring with clean engine oil and install it on the filter cap. 6. Check the filter housing for any debris and remove if necessary. 7. Insert a new filter element into the oil filter cap. All information subject to change without notice. 93 DDC-SVC-MAN-0209 Copyright © 2019 DETROIT DIESEL CORPORATION