MAN — How to Replace the Lubricating Oil and Oil Filter

How to Procedures NOTICE: The oil filter bypass valve is very important to the operation of the engine. If the valve becomes damaged, the oil filter will be bypassed at all times. This allows unfiltered debris to flow throughout the entire lubrication system and may cause severe engine damage. 8. Inspect the oil filter bypass valve (3) in the end of the standpipe (2) in the oil filter housing. See illustration below. A broken bypass valve (1) is shown on the right. Repair as necessary. NOTICE: On some chassis models the air filter housing may interfere with installing the oil filter cap and filter element straight into the housing.

If this is the case, loosen or remove the air filter housing to allow for proper oil filter installation. Installing the filter element on an angle may damage the oil filter standpipe or bypass valve. 9. Insert the filter element and cap assembly into the housing. Torque the cap to 40 to 50 N·m (30 to 37 lb·ft). 10. Place a suitable drain pan, 47 L (50 qt) or more, under the oil pan. NOTE: The oil pan contains multiple plugs that may be used for various options and applications. The oil drain plug is the lowest plug on the oil pan. 11. Carefully unscrew the oil drain plug, and allow the oil to drain out. 12. Discard the oil drain plug sealing O-ring. 13.

Install the oil pan drain plug with a new O-ring and torque the plug: On a plastic oil pan, torque plug to 45 N·m +/- 7 N·m (33 lb·ft +/- 5 lb·ft). On an aluminum oil pan, torque plug to 60 N·m +/- 9 N·m (44 lb·ft +/- 6 lb·ft ). 94 All information subject to change without notice. Copyright © 2019 DETROIT DIESEL CORPORATION DDC-SVC-MAN-0209