OPERATION Explanation of components Switches E.C.S.S. switch 0. (option) If the machine is traveling or the work equipment is raised, the moment the E.C.S.S. switch is turned ON, the work equipment will move. If the E.C.S.S. system is switched on, the work equipment may move. Never turn the E.C.S.S. switch ON during inspection or maintenance. The work equipment will move and this will create a dangerous situation. NOTICE Always stop the machine and lower the work equipment to the ground before operating the E.C.S.S. switch. When carrying out inspection and maintenance, first lower the work equipment to the ground, then turn the E.C.S.S.
switch OFF before starting the inspection and maintenance operation. When carrying out leveling work, turn the E.C.S.S. switch OFF. The E.C.S.S. is a device that uses the hydraulic spring effect of an accumulator to absorb the vibration of the chas- sis during travel and allows the machine to travel smoothly and at high speed. This switch (6) is used to turn the E.C.S.S. ON and OFF. Position (a): ON The pilot lamp (A) lights up and the E.C.S.S. is actuated. Position (b): OFF The E.C.S.S. is not actuated. REMARK The E.C.S.S.
is automatically actuated when the travel speed becomes more than 6 km/h (3.7 MPH); when the travel speed goes below 5 km/h (3.1 MPH) it is automatically disengaged (when 20.5-25 tires are used). Lamp switch 0. This switch (7) is used to light up the front lamps, side clear- ance lamps, tail lamps, and instrument panel. Position (a): OFF Lamps go out. Position (b): Side clearance lamps, tail lamps, and instrument panel light up. Position (c): Head lamps light up in addition to lamps at (b) position. REMARK The lamp switch can be operated regardless of the posi- tion of the lever. 3-31 WARNING