HYDRAULIC UNIT 46 B Remote Control Valve Coupler Connecting and Disconnecting Pressure Returning To avoid personal injury or death: A Stop the engine and relieve pressure before connecting or disconnecting lines. A Do not use your hand to check for leaks. C Connecting 1. Clean both couplers. 2. Remove dust plugs. 3. Insert the implement coupler to the tractor hydraulic coupler. 4. Pull the implement coupler slightly to make sure couplers are firmly connected. A Do not hold the lever in the "pull" or "push" position once the remote cylinder has reached the end of the stroke, as this will cause oil to flow through the relief valve.
Forcing oil through the relief valve for extended periods will overheat the oil. A When using the tractor hydraulic system to power front loader, do not operate boom and bucket cylinders simultaneously. C Disconnecting 1. Lower the implement first to the ground to release hydraulic pressure in the hoses. 2. Clean the couplers. 3. Relieve pressure by moving hydraulic control levers with engine shut off. Pull the hose straight from the hydraulic coupler to release it. 4. Clean oil and dust from the coupler, then replace the dust plugs. A Connect the pressure of load side of implement cylinders to ports [B] or [D] which have built in load check valve to prevent leak down.
A To use the single-acting cylinder with the float valve, connect this cylinder to the [B] or [D] port. To extend a single-acting cylinder, pull the remote control valve lever rearward. To retract a cylinder, push it fully forward to the "FLOAT" position. Do not hold it in the down position, the transmission fluid may be overheat. A Your local KUBOTA Dealer can supply parts to adapt couplers to hydraulic hoses. B Flow Control Valve (option) The optional flow control valve may be added for the following purposes. 1. To operate within limits, the remote control valves (2) or (3) above the flow control valve (4) and the 3-point hitch at the same time without one affecting the other. 2.
To operate within limits, the remote control valves (2) or (3) above the flow control valve (4) and the other remote control valve (1) at the same time without one affecting the other. Activating the remote control valve (1) will interrupt the operation of the 3-point hitch. 3. To maintain within limits, the constant speed of an attachment (hydraulic motor RPM, for example) when connected to the remote control valves (2) or (3) above the flow control valve (4).
A At slower engine speeds the total hydraulic flow rate may be inadequate for simultaneous operation of the remote control valves (2) or (3) and the 3-point hitch or the remote control valve (1), or operation of an attachment connected to the remote control valves (1)(2)(3). Under these conditions, the engine speed must be increased to provide additional hydraulic flow. A The remote control valves (2) and (3) above the flow control valve (4) can not be operated at the same time. Lever (1) Lever position Z (detent) X Y Port (A) in Float in out (B) out out in Lever (2) Lever position Z(detent) X Y Z(detent) Port (C) in out (D) out in