Instructions for ST assembly 210 MW Bandel India Document number: S12003-YK09-05MAA-747002 Tylova 57l 31600 Plzeň l Českб Republika · Place the couples of wedges ( pos. 14, 15, 16 ) on the supporting plates ( pos. 1, 1, 2 ), the required height of the upper surface of wedges will be set by means of the optic & laser leveling and T-square with length of 3 m , differences of height will be compensated by inserting of additional shims from the set (from pos. 3 up to 11 ), initial setting of wedges has to allow the changing of height in future (always up and down), it is allowed to insert max. 2pcs of additional shims under each couple of wedges!
The shifting of wedges off from initial mutual position in one couple must not exceed 30% of their length. Work status The foundation plates and wedges of the turbine are ready for assembly of the pedestals of bearing’s stands (HP , IP and LP) and the · Uložte dvojice klнnů ( poz. 14, 15, 16 ) na zбkladovй podložky ( poz.1, 1, 2 ), požadovanб vэškovб poloha hornнch ploch klнnů se nastavн p omocн nivelačnнho měřenн a přнměrnйho pravнtka o dйlce 3 m , vэškovй rozdнly se eliminujн vloženнm plechů ze sady ( poz. 3 až 11 ), počбtečnн nastavenн klнnů musн umožnit budoucн změnu vэšky vždy nahoru i dolů, vklбdat je povoleno max. 2ks plechů pod každou dvojici klнnů!
Vzбjemnй vysunutн klнnů nesmн nikdy překročit 30% jejich dйlky . Stav pracн Zбkladovй podložky a klнny turbiny jsou připraveny pro montбž kozlнků ložiskovэch stojanů (VT, ST a NT) a spodku NT vnějšнho Date: 12.11.2013 Page 121 / 278 Prepared: O.Baroch Last Revision: Approved: P.Lešetickэ