Instructions for ST assembly 210 MW Bandel India Document number: S12003-YK09-05MAA-747002 Tylova 57l 31600 Plzeň l Českб Republika grouting check if the anchor bolts are tighten by the final prescribed torque. · Before the embedding lock the mutual position of wedges in each pairs with the tack-welding according to Tp6075643 by the fillet weld a4 , use the coated electrode 111/ESAB-OK 48.00 . Attention: Tack-welding for fixing of the mutual position of the wedges in every pairs can be done only after the final machine leveling and after the tightening of the anchor bolts just before the embedding of the foundation elements into the grouting compound!.
· Instructions for embedding of anchor bolts and pedestals into special compound are mentioned in document DSPW Main assembly Manual” no. S12003-YK09-05MAA- 747001 zda jsou kotevnн šrouby utaženy finбlnнm předepsanэm utahovacнm momentem. · Pojistěte vzбjemnou polohu všech klнnů ve dvojicнch stehovбnнm dle vэkresu Tp6075643 koutovэm svarem a4 , použijte obalenou elektrodu 111/ESAB-OK48.00 . Upozorněnн: Stehovбnн vzбjemnй polohy klнnů v každй dvojici se provбdн až po konečnйm vyrovnбnн stroje, po utaženн kotevnнch šroubů, těsně před zбlivkou zбkladovэch prvků do zбlivkovй hmoty.
· Instrukce pro zбlivku kotevnнch šroubů a kozlнků do speciбlnн hmoty jsou uvedeny v dokumentu DSPW Hlavnн montбžnн manuбl“ č. S12003-YK09-05MAA-747001 · Date: 12.11.2013 Page 140 / 278 Prepared: O.Baroch Last Revision: Approved: P.Lešetickэ