Instructions for ST assembly 210 MW Bandel India Document number: S12003-YK09-05MAA-747002 Tylova 57l 31600 Plzeň l Českб Republika · Hang the assembled cover on crane according to drawing Tp6078748 and move it on the wooden supports onto the place according to drawing “Lay - down plan” or on another area with enough loading capacity (weight of the cover is max. 51 tons). Work status: The cover of LP outer casing is assembled together, the tightness welds are completed. Upper parts of deflectors are installed.
· Zavěste smontovanй vнko na jeřбb dle vэkresu Tp6078748 a uložte vнko na dřevěnй podklady na mнsto dle vэkresu „Odklбdacн plбn“ nebo na jinou plochu s dostatečnou nosnostн (hmotnost sestavenйho vнka je max 51 tuny). Stav pracн: Vнko vnějšнho NT tělesa je smontovбno včetně provedenн těsnostnнch svarů a instalace hornнch čбstн deflektorů . Preparation of LP middle casing for LP Přнprava NT střednнho tělesa na vloženн diaphragm inserting · Wash carefully off preservation from the inner surfaces of middle part of LP inner casing. Grease slightly the grooves for diaphragms and the other contact surfaces with the anti- sizing compound Molykote G Rapid+.
· Lightly grease the grooves for diaphragms and contacts surfaces with the inner elements by anti-sizing compound Molykote G Rapid+ . For lifting of the cover use the delivered ropes according to Tp6078748 . Work status: LP middle casing is ready for assembly of diaphragms. rozvбděcнch kol · Smyjte důkladně konzervaci ze všech vnitřnнch ploch spodku střednнho NT tělesa. Drбžky pro rozvбděсн kola a ostatnн kontaktnн plochy lehce namažte protizбděrovou mazacн pastou Molykote G Rapid+ . · Lehce namažte drбžky pro rozvбděсн kola a kontaktnн plochy s vnitřnнmi dнly protizбděrovou pastou Molykote G Rapid+ . Pro zvedбnн vнka použijte dodanб lana dle vэkresu Tp6078748 . Stav pracн:
NT střednн těleso je připraveno pro montбž rozvбděcнch kol . Assembly of the covers with oil seals and Montбž vнk olejovэch vložek a těles ucpбvek: · Montujte n osiče olejovэch vložek (vнk a) Tp6076595 (zadnн NT těleso ) a Tp6071722 ( přednн NT těleso ) k ložiskovэm vanбm NT tělesa včetně těsněnн (olejovб vložka je nezбvisle polohovatelnб vůči stojanu a ucpбvce). Montбž proveďte ještě před instalacн těles NT ucpбvek . gland bodies: · Assemble the carriers of the oil seals (covers) Tp6076595 (rear LP casing) and Tp6071722 (front LP casing) into the bearing’s vans of LP casing) including the gaskets (position of the oil covers can be independently changed against the stand and the gland).
Carry out the assembly just before LP gland’s bodies installation. Date: 12.11.2013 Page 150 / 278 Prepared: O.Baroch Last Revision: Approved: P.Lešetickэ