DOOSAN ŠKODA POWER — DOOSAN ŠKODA POWER Steam Turbine Assembly Manual

Instructions for ST assembly 210 MW Bandel India Document number: S12003-YK09-05MAA-747002 Tylova 57l 31600 Plzeň l Českб Republika possible to change the position of LP inner casing after boxing up of LP turbine part (set- wedges instead the final supporting plates under the feet of LP inner casing) . That’s why the setting of the LP flow path is possible to change easy and eliminate the appropriate changes which are caused by the deformation of foundation after boxing up of the turbine casing. A nd that’s why the installation of the final supporting plates of LP inner casing is carried out just before the start-up of turbine.

tělese tak, aby bylo možno měnit jeho polohu i po zavřenн NT dнlu (stavitelnй klнny namнsto finбlnнch podložnэch desek pod patkami NT vnitřnнho tělesa). Proto ustavenн NT průtočnй čбsti lze snadno měnit a eliminovat tak přнpadnй změny způsobenй deformacemi zбkladu po zavřenн těles . P roto se instalace finбlnнch podložnэc h desek NT vnitřnнho tělesa provбdн až bezprostředně před najetнm turbiny. Bearings inspection and assembly: Lifting yokes for the radial bearing shells dismantling: For dismantling of the lower parts of radial bearing shells (without the necessity to remove turbine rotor) there are delivered the lifting yokes together with turbine.

Yokes Tp6072967 are used for ligtly lifting of rotor and due taking out of the bottom halves of bearing shells). Do not lift the rotor more then half of the minimum radial clearances in steam flow path ( the minimum drawing clearance in the steam flow path is 0,85 mm for HP, 0,28 mm for IP part and 0,23 mm for LP part). The yoke can be used only for the lifting of the one journals and it is prohibited to hang the rotor on the 2 yokes at the same time . Ložiska – kontrola a montбž: Zvedacн třmeny pro demontбž pбnvн radiбlnнch ložisek: Pro demontбž spodků pбnvн radiбlnнch ložisek (bez nutnosti vyjнmat rotor turbiny) jsou dodбny se strojem Zvedacн třmeny č.v.

Tp6072967 (třmeny se použijн pro jemnй přizvednutн rotoru, pro vyjmutн spodků ložiskovэch pбnvн). Zvedбnн rotorů provбdějte pokud možno jen na polovičnн hodnoty minimбlnн radiбlnн vůle v průtočnй čбsti ( minimбlnн vэkresovб vůle v průtočnй čбsti je 0,85 mm u VT, 0,28 mm u ST a 0,23 mm u NT) . Třmen se použнvб vždy jen pro zvednutн jednoho z ložiskovэch čepů rotoru, je zakбzanй zavěsit rotor do 2 třmenů současně . Date: 12.11.2013 Page 190 / 278 Prepared: O.Baroch Last Revision: Approved: P.Lešetickэ