DOOSAN ŠKODA POWER — DOOSAN ŠKODA POWER Steam Turbine Assembly Manual

Instructions for ST assembly 210 MW Bandel India Document number: S12003-YK09-05MAA-747002 Tylova 57l 31600 Plzeň l Českб Republika Assembly of stop valves Montбž rychlozavernэch ventilů · Stop valve in accordance with the drawing Tp6067929 . · Estimated form of delivery: valve body with assembled internal parts and with the blinded necks is inside the box sepparately from servomotor, ready for putting into position. · The valve bodies and valve supporting unwrapping, wash the preservation from the contact surfaces, uncover the contact surfaces for the servomotors attachment and the blinds of necks just before the part assembly.

· Install of the stop valve supporting into foundation · Apply the sliding varnisch Molykote D321R on the thread of screws pos.43 (M39x3) of valve chamber and on the face of thein nuts, see in Tp6073670 . Hang the valve body on crane wind the rope under body (the weight without servomotor is 2,1 tons). · Fix the stop valve to valve chamber by means of min. 8 pcs. of nuts (pos.57 - Tp6073670) and tighten them by aprox. 50% of their prescribed torque and fix stop valve on supporting · Attach the counterflange of the steam pipline to the flange of stop valve, instead of the · RZ ventil dle vэkresu Tp6067929 . · Uvažovanб forma dodбnн:

těleso ventilu s namontovanэmi vnitřnнmi čбstmi a zaslepenэmi otvory v bedně odděleně od servopohonu, připraveno k použitн. · Těleso ventilu a podpěru ventilu vybalit, stykovй plochy přнrub dekonzervovat a odmastit. Kontaktn н plochy pro upevněnн servomotoru a zбslepky hrdel potrubн odkrэvat vždy až těsně před montбžн. · Nainstalujte podpěru RZ ventilu do zбkladu · Mazat zбvity šroubů poz. 43 (M39x3) ventilovй komory a čela jejich matic kluznэm lakem Molykote D321R viz. Tp6073670 , zavěsit těleso ventilu na jeřбb opбsбnнm (hmotnost bez servopohonu je 2,1 tuny). · Upevnit RZ ventil k ventilovй komoře použitнm min.

8 matic (poz.57 Tp6073670 ) a jejich utaženнm na cca 50% předepsanйho utahovacнho momentu a upevnit RZ ventil na podpěru. · Upevnit protipřнrubu parovodu přнvodu pбry k RZ ventilu, namнsto těsněnн poz. 106 vložit Date: 12.11.2013 Page 219 / 278 Prepared: O.Baroch Last Revision: Approved: P.Lešetickэ