Terex TL160 — 5.2.2 Assembly of work attachments

Working Operation 5 Procedure for changing work attachments with hydraulic quick-attach system (option) Lower the work attachment onto the ground and position so that it cannot tilt. Switch off the diesel engine. Switch on the ignition. Operate the push-button switches (27/5) for pres- sure relief. In case of hydraulically controlled additional tools: Release the hydraulic connections on both distrib- utor blocks. + - P 12 Km/h 00014,0 h 0 4/4 1/2 Ball valve in position “Unlock quick-attach system” (Fig. 28). 5 Start the diesel engine. Unlock the quick-attach system (27/5) and move out of the work attachment. Take up new work attachment and lock by press- ing the push-button switch (27/5).

Danger to life due to incorrectly fastened work attachments. Perform a visual check to ensure that the quick-attach system is correctly locked. Switch off the diesel engine. Switch on the ignition. 53 Operate the push-button switches (27/5) for pres- sure relief. P Ball valve in position “Quick-mount hitch locked” (Fig. 28). Connect the hydraulically operated work attach- ment to the connection of the additional control cir- cuit. Fig. 27 Operating the quick-attach system Machine damage due to additional control circuit which has not been switched off. The additional control circuit (27/ 53) must be switched off unless a hydraulically op- erated additional attachment is connected.

L864-504 Fig. 28 Releasing and locking the hydraulic quick-attach system 57/112 TL160 Operating Manual 12.9.08 Version 1.0