Working Operation 5 5.3 Notes on how to work with the machine 5.3.1 Loading During transport, the bucket - either filled or empty - must be kept as close to the ground as possible. If possible, avoid long transport distances! Attention For loading, lower the bucket and position the cutting edge parallel to the ground. Re- duce driving speed by inching as required. Move the bucket into the material to be loaded. As soon as the bucket is filling, slightly raise the lift frame and tilt back the bucket. For dumping, raise the bucket until it is above the point of dumping and dump the material.
5.3.2 Scraping and grading Lower the lift frame and move the cutting edge into the ground keeping a flat angle of inclination. Do not penetrate too deeply to ensure smooth remov- al of earth. During this operation, the depth is only to be lev- eled by moving the bucket in and out. 5.3.3 Excavating To dig out an excavation, strip layers which are as regular as possible. Plan the excavating work in such a way as to en- able the wheel loader to drive forward with full bucket out of the excavation. Keep the outward run of the excavation as flat as possible. 58/112 TL160 Operating Manual 12.9.08 Version 1.0