Care and Maintenance 7 7.8.7.4 Tensioning the V-belt Slacken the fastening screws 58/1, 58/3 and 59/1. Rotate the generator (58/2) until the tension is correct. Re-tighten the fastening screws 58/1, 58/3 and 59/1. 1 Check the tension again. 2 3 Fig. 58 Tensioning and replacing V-belts 7.8.7.5 Changing V-belts Slacken the fastening screws 58/1, 58/3 and 59/1. Rotate the generator against the direction of tensioning. Remove the V-belt and fit on an appropriately sized new one. 1 Rotate the generator (58/2) in the direction of tensioning until the V-belt tension is correct. Re-tighten the fastening screws 58/1, 58/3 and 59/1. Check the tension again.
Attention If V-belts have been replaced, their tension must be checked again after approx. 20 operating hours. Fig. 59 Tensioning and checking V-belts 88/112 TL160 Operating Manual 12.9.08 Version 1.0