Care and Maintenance 7 7.8.8 Checking the valve lash Test the valve lash (60/1) on a cold engine by placing a feeler gauge between the upper part of the tappet (60/3) and the rocker arm (60/2). 2 5 4 The correct valve lash is as follows: Inlet valve = 0.20 mm Outlet valve = 0.45 mm 1 If necessary, adjust the valve lash as follows: 3 Slacken counternut (60/4). Using a screwdriver, adjust the setting screw (60/5) in such a way that the correct valve lash (60/1) is obtained after the lock nut is tightened. Re-tighten counternut. Fig. 60 Adjusting the valve lash Attention The 1st cylinder is located at the front on the fan side of the engine. Valve adjustment Remove the cylinder head cover.
Turn the crankshaft in normal direction of rotation until the inlet valve 61/7 of cylinder no.4 begins to open; the outlet valve 61/8 of the same cylinder is not yet closed completely. Check the valve lash of valves 61/1 and 61/2 of cylinder no. 1 and adjust if required. Tab. 30 Cylinder and valve numbers Adjust the valves 61/3 and 61/4 of cylinder no. 2, as described above for the valves of cylinder no. 4, for overlap. Then check the valve lash of valves 61/5 and 61/6 of cylinder no. 3 and adjust if required. 1 2 3 4 5 6 7 8 Adjust the valves 61/1 and 61/2 of cylinder no. 1 for overlap. Check the valve lash of valves 61/7 and 61/8 of cylinder no. 4 and adjust if required.
Adjust the valves 61/5 and 61/6 of cylinder no. 3 for overlap. Check the valve lash of valves 61/3 and 61/4 of cylinder no. 2 and adjust if required. Re-mount the cylinder head cover along with a new gasket. Fig. 61 Valve adjustment 89/112 TL160 Operating Manual 12.9.08 Version 1.0 Cylinder no. 1 2 3 4 Valve no. 1 2 3 4 5 6 7 8 Valve I = inlet O = outlet I O I O I O I O