Care and Maintenance 7 7.8.9 Brakes 7.8.9.1 Checking the brake disc thickness This check must be performed twice on each of the two axles. 54 Operate the parking brake preselection switch (62/54), thereby applying the parking brake. Open the first inspection hole (63/1) on the front axle. P Check the wear of the brake discs using a measuring gauge. L864-717 Attention Minimum thickness of brake discs: S= 4.5 mm Fig. 62 Operation of parking brake Close the inspection hole. n Close the inspection hole. Check the remaining brakes of the other axle side and the rear axle.
7.8.9.2 Bleeding the brake Attention Collect the escaping oil in a suitable container and dispose of in compliance with regulations. Attention Two persons are required to bleed the brakes. Remove the cover on the front-end above the axle. Let the engine run at medium speed. Fig. 63 Checking brake discs Fully depress the brake pedal Connect the bleeder hose to the first bleeder screw (64/1) of the front axle and route it into the collection bottle. Open the bleeder screw (64/1) until the brake fluid (hydraulic oil) escapes without bubbles. Remove the bleeder hose and re-tighten the bleeder screw.
Connect the bleeder hose to the second bleeder screw (64/1) of the front axle and route it into the collection bottle. Open the bleeder screw (64/1) until the brake fluid (hydraulic oil) escapes without bubbles. Remove the bleeder hose and re-tighten the bleeder screw. Fig. 64 Bleeding the brake 90/112 TL160 Operating Manual 12.9.08 Version 1.0