Terex TL160 — 7.8.9 Brakes

Care and Maintenance 7 Connect the bleeder hose to the first bleeder screw (64/2) of the rear axle and route it into the collection bottle. Open the bleeder screw (64/2) until the brake fluid (hydraulic oil) escapes without bubbles. Remove the bleeder hose and re-tighten the bleeder screw. Connect the bleeder hose to the second bleeder screw (64/2) of the rear axle and route it into the collection bottle. Open the bleeder screw (64/2) until the brake fluid (hydraulic oil) escapes without bubbles. Remove the bleeder hose and re-tighten the bleeder screw. Connect the bleeder hose to the bleeder screw on the inch valve of the hydraulic “Travel” pump and route it into the collection bottle.

Open the bleeder screw until the brake fluid (hydraulic oil) escapes without bubbles. Remove the bleeder hose and re-tighten the bleeder screw. Re-mount the cover on the front-end. 7.8.9.3 Adjusting the brake disc play 47 mm Place the machine on a level surface and secure it with chocks to prevent it from rolling away. Release the hand brake L864-719 Do not switch off the engine! Fig. 65 Adjusting the brake Remove the screw (65/1) along with the retaining fixture (65/2) on the left-hand brake of the front axle. Move the adjusting device (65/3) to the left (anti- clockwise) until the stop. Move the adjusting device 3 full turns to the right (clockwise). Re-install the retaining fixture.

The play between the brake discs is now adjusted. Adjust the remaining brakes of the other axle side and the rear axle. 7.8.9.4 Adjusting the spring-loaded cylinder Slacken counternut (65/5). Adjust the mechanical unlocking mechanism (65/4) to 47 mm. Re-tighten counternut. Adjust the spring-type actuators of the other brakes accordingly. 91/112 TL160 Operating Manual 12.9.08 Version 1.0