Terex TL160 — 7.8.11 Hydraulic oil suction filter

Care and Maintenance 7 7.8.11 Hydraulic oil suction filter Machine damage due to dirt reaching the uncovered hydraulic oil tank. Before starting, clean all parts above the tank. Attention After a larger repair job, renew the filter cartridge following the test run. Changing the filter insert Switch off the engine. Open the breather (67/2). Loosen the filter cover (68/1) of the suction filter (67/1) with the aid of a tool. 2 L864-722 Remove the assembly (68/10) by turning and completely removing the filter cover, paying attention to the O-ring (68/3). Fig. 67 Hydraulic oil tank Attention Remove the suction filter above a receptacle for the collection of waste oil.

Grasp the assembly by the filter cover (68/1) and unscrew the valve (68/2). Remove the filter insert and dispose of according to regulations. Clean the filter cover with centre rod (68/8) and the valve with diesel oil or benzine. While doing so, pay attention to the retaining plate (68/6) along with the seals (68/5), (68/7) and the compression spring (68/4). Check the O-ring (68/3) and seals (68/5), (68/7), (68/11) and replace any damaged part. Place surface “A” of the filter cover on a solid base, push a new filter insert onto the centre rod and fit onto the seal (68/5). Push the filter insert downward against the springs and tighten the valve (68/2) by hand.

Push the assembly (68/10) into the housing (68/12), tighten the filter cover by hand and ensure that the O-ring (68/3) is in exactly the right position. Fig. 68 Changing the filter insert of the suction filter Screw back on the filter cover (68/1) and tighten by hand. Check the tightness of the filter by means of a test run. 93/112 TL160 Operating Manual 12.9.08 Version 1.0