Care and Maintenance 7 7.8.12 Hydraulic oil return filter Machine damage due to dirt reaching the uncovered hydraulic oil tank. Before starting, clean all parts above the tank. Attention After a larger repair job, renew the filter cartridge following the test run. 3 Changing the filter insert Switch off the engine. Open the breather (69/2). Remove the return filter cover (69/3). Pull out the filter bowl (70/2) along with the filter insert (70/3). 2 Remove the filter insert from the filter bowl by turning and pulling at the same time. Fig. 69 Hydraulic oil tank L864-723 Clean the filter bowl using appropriate detergents.
Ensure that the O-rings (70/4-6) are in perfect condition and replace any damaged part. Insert a new filter element in the filter bowl. Re-insert the filter bowl along with the cartridge into the hydraulic oil tank. Apply a light coat of grease to the cover seal. Install the return filter cover and tighten by hand. Check the tightness of the filter by means of a test run. Fig. 70 Changing the filter insert of the return filter 94/112 TL160 Operating Manual 12.9.08 Version 1.0