Care and Maintenance 7 7.8.14 Axles General The axle oil must be changed at operating temperature. Attention Collect the waste oil in a suitable container and dispose of in compliance with regulations. Machine damage due to insufficient oil in axles. After filling the axles with oil, move the machine for approx. 5 minutes to ensure that the oil is evenly distributed. After 5 minutes, check the oil level again, and top up if necessary. 7.8.14.1 Front axle differential Checking the axle oil level Park the machine on level ground. Remove the inspection-filling plugs (73/1). Check if the oil is up to the edge of the inspection- filling hole. Top up oil if required.
Carefully close the inspection-filling plugs. Changing axle oil Park the machine on level ground. Clean the area around the inspection-filling plugs (73/1) and drain plugs (73/2). Attention Fig. 73 Checking / replacing the front axle oil Collect the waste oil in a suitable container and dispose of in compliance with regulations. Open the inspection-filling plugs (73/1). Open the drain plugs (73/2) on the differential and brake housings and drain oil. Flush out the axle if necessary. Carefully close the drain plugs. Pour in oil using the inspection-filling hole until oil escapes from the other inspection-filling hole. Carefully close the inspection-filling plugs.
96/112 TL160 Operating Manual 12.9.08 Version 1.0