Cooling Fan Belt Tensioner QSB4.5 and QSB6.7 Page A-12 Section A - Adjustment, Repair, and Replacement Install Always use the correct thermostat and do not operate the engine without a thermostat installed. The engine can overheat if operated without a thermostat because the path of least resistance for the coolant is through the bypass to the pump inlet. An incorrect thermostat can cause the engine to overheat or run too cold. NOTE: If a previously installed thermostat is being used, make sure a new thermostat seal is used. CAUTION Install the thermostat into the thermostat housing. Install the water outlet connection and mounting capscrews. Tighten the capscrews. Torque Value:
10 N•m [ 89 in-lb ] Cooling Fan Belt Tensioner Maintenance Check With the engine stopped, check the tensioner arm, pulley, and stops for cracks. If any cracks are found, the tensioner must be replaced. With the belt installed, verify that neither tensioner arm stop is in contact with the spring case stop. If either of the stops is touching: Verify the correct belt part number is installed. If the correct belt is installed, replace the belt. Refer to Procedure 008-002 in Section A. After replacing the belt, if the tensioner arm stops are still in contact with the spring case stop, replace the tensioner.