QSB4.5 and QSB6.7 Cooling Fan Belt Tensioner Section A - Adjustment, Repair, and Replacement Page A-13 With the belt removed, verify that the tensioner arm stop is in contact with the spring case stop. If these two are not touching, the tensioner must be replaced. After replacing the belt, if the tensioner arm stop is still in contact with the spring case stop, the tensioner MUST be replaced. Check the location of the drive belt on the belt tensioner pulley. The belt should be centered on, or close to the middle of, the pulley. Misaligned belts, either too far forward or backward, can cause belt wear, belt roll-offs, or increase uneven tensioner bushing wear. Remove the drive belt.
Refer to Procedure 008-002 in Section A. With the belt removed, verify that the tensioner arm stop is in contact with the spring case stop. If they are not touching, the tensioner must be replaced.