Drive Belt, Cooling Fan QSB4.5 and QSB6.7 Page A-14 Section A - Adjustment, Repair, and Replacement Drive Belt, Cooling Fan General Information Due to the number of drive belt arrangements, this procedure does not cover all available cooling fan drive belt routing. To make sure the cooling fan drive belt is routed correctly upon installation, make a diagram of the cooling fan belt routing prior to removing the belt as shown in the illustration. The cooling fan belt routing typically consists of the following components, but may not include all of them:
1 Crankshaft pulley/vibration damper 2 Fan pulley 3 Water pump pulley 4 Refrigerant compressor pulley 5 Alternator pulley 6 Tensioner idler pulley. NOTE: Some engine driven belts are installed/supplied by the vehicle's original equipment manufacturer (OEM). See the OEM service manual for removal and installation instructions. Preparatory Steps WARNING Batteries can emit explosive gases. To reduce the possibility of personal injury, always ventilate the compartment before servicing the batteries. To reduce the possibility of arcing, remove the negative (-) battery cable first and attach the negative (-) battery cable last. Disconnect the batteries. Refer to the OEM service manual.
Remove The belt tensioner is spring-loaded and must be pivoted away from the drive belt. Pivoting in the wrong direction can result in damage to the belt tensioner. CAUTION The belt tensioner winds in the direction that the spring tang is bent over the tensioner body. To loosen the tension on the belt, rotate the tensioner to wind the spring tighter.