QSB4.5 and QSB6.7 Drive Belt, Cooling Fan Section A - Adjustment, Repair, and Replacement Page A-15 Applying excessive force in the opposite direction of windup or after the tensioner has been wound up to the positive stop can cause the tensioner arm to break. NOTE: Make a diagram of the belt arrangement prior to removing the drive belt. This aids in installation and proper routing of the cooling fan drive belt. NOTE: The location of the belt tensioner can vary, depending on the front engine accessory arrangement. CAUTION Pivot the tensioner in the direction of the spring tang to remove the belt. Remove the belt. Clean and Inspect for Reuse Inspect the drive belt for damage.
Transverse (across the belt) cracks are acceptable. Longitudinal (direction of belt ribs) cracks that intersect with transverse cracks are not acceptable. If the belt is frayed, punctured, or material is missing, the belt is unacceptable for reuse and must be replaced. Inspect the belt grooves for: Embedded debris Uneven/excessive rib wear Exposed belt cords. Inspect the backside of the belt for: Glazing (high heat) Embedded debris If any of the above conditions are present, the belt is unacceptable for reuse and must be replaced. Exposed belt cords. Inspect the idler and drive pulleys for wear or cracks.
Plastic pulleys often have a build-up of road dirt and belt material that is not to be confused with wear. The dirt can be removed with a suitable tool to check for wear. Clean, check, and reuse all pulleys in the front end accessory drive if not damaged, rather than replacing. Pulleys damaged from embedded debris MUST be replaced. Inspect the tensioner. Refer to Procedure 008-087 in Section A.