Cummins — 4021531

Drive Belt, Cooling Fan QSB4.5 and QSB6.7 Page A-16 Section A - Adjustment, Repair, and Replacement Inspect all system pulleys for embedded debris: Rocks, stones Metal Belt material. Remove the debris from the grooves of the pulley. If the pulley has been deformed as a result of foreign material embedment, the pulley MUST be replaced. Install CAUTION The belt tensioner is spring-loaded and must be pivoted away from the drive belt. Pivoting in the wrong direction can result in damage to the belt tensioner. Route the drive belt on the engine using the belt diagram created in the Remove section. Do not install the belt over the water pump pulley at this time.

Pivot the tensioner in the direction of the spring tang and install the drive belt, slipping the belt over the water pump pulley last. Slowly release the tensioner to apply tension to the drive belt. Check the alignment of the belt with the tensioner and the rest of the front end accessory drive. Finishing Steps Batteries can emit explosive gases. To reduce the possibility of personal injury, always ventilate the compartment before servicing the batteries. To reduce the possibility of arcing, remove the negative (-) battery cable first and attach the negative (-) battery cable last. WARNING Connect the batteries. Refer to the OEM service manual. Operate the engine and check for belt squeal.

Excessive belt squeal indicates belt slippage. If belt squeal is present, check the routing of the belt to make sure that the belt is installed correctly on each pulley.