Cummins — 4021531

QSB4.5 and QSB6.7 Lubricating Oil and Filters Section 5 - Maintenance Procedures at 500 Hours or 6 Months Page 5-11 Prime The fuel pump high-pressure fuel lines and fuel rail contain very high-pressure fuel. Never loosen any fittings while the engine is running. Personal injury and property damage can result. WARNING To prime the engine use the OEM installed priming device. Typically, a priming pump is installed at or near the pre-filter. See the OEM's instructions for the number of strokes (hand primer) or the cycle time (electric priming pump) needed to prime the low pressure system. NOTE: It is not necessary to vent air from the high pressure system before starting the engine. NOTE:

To prevent damage to the hand pump priming seals, clean the fuel pump head and priming pump with Quick Dry Spray Cleaner, Part Number 3824510, or equivalent, and compressed air prior to priming the fuel system. Operate the engine and check for leaks. Lubricating Oil and Filters Drain Some state and federal agencies have determined that used engine oil can be carcinogenic and cause reproductive toxicity. Avoid inhalation of vapors, ingestion, and prolonged contact with used engine oil. If not reused, dispose of in accordance with local environmental regulations. WARNING WARNING To reduce the possibility of personal injury, avoid direct contact of hot oil with your skin.

Change the lubricating oil and filter(s) at the specified oil change interval. See the Maintenance Schedule to find the correct change interval for your application. NOTE: For most engines, use a container that can hold at least 20 liters [21 qt] of lubricating oil. Some engines can be equipped with an increased capacity oil pan requiring a container that will hold 28 liters [30 qt] of lubricating oil. Operate the engine until the water temperature reaches 60°C [140°F]. Shut off the engine. Remove the oil drain plug. Drain the oil immediately to be sure all the oil and suspended contaminants are removed from the engine.