Lubricating Oil and Filters QSB4.5 and QSB6.7 Page 5-12 Section 5 - Maintenance Procedures at 500 Hours or 6 Months Remove Clean the area around the lubricating oil filter head. Use the oil filter wrench, Part Number 3400158, to remove the filter. Clean the gasket surface of the filter head. NOTE: The o-ring can stick on the filter head. Be sure it is removed before installing the new filter. Install Use the correct oil filter. See the Cummins®/Fleetguard®/Nelson filter specifications for the correct oil filter part number. CAUTION The lack of lubrication during the delay until the filter is pumped full of oil at start-up can damage the engine.
Use clean 15W-40 oil to coat the gasket surface of the filter. Fill the filter with clean 15W-40 oil. Apply a light film of lubricating oil to the gasket sealing surface before installing the filter. NOTE: Be careful that no debris is poured into the filter. If using an oil supply with a metallic or plastic seal under the cap, be careful to peel the seal back. Puncturing the seal with a knife or sharp object can create debris in the oil container. CAUTION Mechanical overtightening of filter can distort the threads or damage the filter element seal. Install the filter on the oil filter head. Tighten the filter until the gasket contacts the filter head surface.
Tighten 3/4 to 1 turn after the gasket makes contact with the filter head.