Komatsu — 24.2 WHEN REQUIRED

24. SERVICE PROCEDURE 9. Replace the corrosion resistor cartridge and open valve 1 . For details of replacement of the corrosion resistor, see “24.8 EVERY 1000 HOURS SERVICE”. 10. Add coolant mixed with antifreeze until it overflows from the water filler. Decide the proportions of antifreeze and water according to the table for the mixing rate of water and antifreeze. 11. To bleed the air from the cooling system, run the engine at low idling for 5 minutes, and for a further 5 minutes at high idling. (When doing this, leave the radiator cap off.) 12. Stop the engine, wait for approx. 3 minutes, then add coolant until the coolant level is near the coolant filler port, and tighten the cap.

Check the coolant level and add coolant if necessary. 3-27