24. SERVICE PROCEDURE 24.2.3 CHECK TRANSMISSION OIL LEVEL, ADD OIL WARNING When checking the oil level, apply the parking brake, and lock the front and rear frames with the safety bar and pin. The oil is at high temperature after the machine has been operated. Always wait for the temperature to go down before starting this operation. Carry out this procedure if there is any sign of oil on the transmission case, or if there is oil mixed with the cooling water. 1. Stop the engine. 2. Use sight gauge G to check the oil level. 3. If the oil level is not within the range at upper area A of the sight gauge, add engine oil through oil filler F . For details of the oil to use, see “20.
USE OF FUEL, COOLANT AND LUBRICANTS ACCORDING TO AMBIENT TEMPERATURE.” 4. If the oil is above the A, remove drain plug 1 and loosen plug 2 to drain the excessive engine oil, then check the oil level again. 5. If the oil level is correct, then tighten the cap. Make an oil level check before starting engine or 60 minutes or more after the engine is stopped. If oil remains at various portions, the correct oil level cannot be measured. The oil level can also be checked at low idling. In this case, the oil should be within the range at bottom area B of the sight gauge. However, the time taken for the oil level to become steady will differ according to the idling speed and the oil temperature.
3-28