24. SERVICE PROCEDURE 24.2.4 CHECK AXLE OIL LEVEL, ADD OIL WARNING When checking the oil level, apply the parking brake, and lock the front and rear frames with the safety bar and pin. The oil is at high temperature after the machine has been operated. Always wait for the temperature to go down before starting this operation. Carry out this procedure if there is any sign of oil on the axle case. Carry out the inspection with the machine on a horizontal road surface. (If the road surface is at an angle, the oil level cannot be checked correctly.) 1. Stop the engine and remove oil level plug 1 . 2. Check that the oil level reaches the bottom of the plug hole. 3.
If the oil is not close to the bottom edge, add axle oil through the hole of plug 1 . For details of the oil to use, see “20. USE OF FUEL, COOLANT AND LUBRICANTS ACCORDING TO AMBIENT TEMPERATURE.” 4. If the oil level is correct, install plug 1 . Tightening torque: 152 ± 24 N·m (15.5 ± 2.5 kgf·m, 112 ± 18 lbft) 3-29