Crankcase W 03-11-01 2011 z Measure the installation depth of the camshaft bearing with the depth measuring appliance from the crankcase joint to the camshaft bearing. Note - Correct the installation depth of the camshaft bearing if necessary. - Installation depth, see schematic diagram. z Remove the assembly tool. Install outer camshaft bearing 6 z Mount outer camshaft bearing. Note - Note position of joint (1), see schematic diagram. - Check that the oil bores (2) in the camshaft bearing and the crankcase match up. - In the camshaft bearing on the flywheel side, the bores (3) for the setting bolts must match up with the camshaft lock. z Insert counterbearing (1) in inner camshaft bearing.
z Insert spindle and fit washer and nut. z Insert extraction bus in outer camshaft bearing. Note - Do not change the installation position of the camshaft bearing. - Make sure that the counterbearing is evenly in contact with the crankcase. 0312 1581 - 0138 7/10 © 11/2004 © 39315 0 © 39315 0 2 3 1 © 39316 0 © 39316 0 1 © 39307 0 © 39307 0