MAINTENANCE 4.8 250 HOUR (3-MONTH) INSPECTION & MAINTE- NANCE PROCEDURES. NOTE Perform all pre-start (every 8-Hour and 50-Hour) inspec- tion & maintenance procedures along with the 120 Hour inspection and maintenance procedures. A. FAN AND A/C BELT WEAR AND TENSION Inspect belts and tensioner assembly on a new ma- chine after the first 50 hours of operation. Then at every 250 hours of engine operation. Measure belt tension on longest span of belt. Ap- ply a 10 kgf (22 lbf) on the belts as indicated in Figure 4.38A and measure the belt deflection. Com- pare to the following table: 4 FIGURE 4.38A ADJUSTING NUT 1.
Fan Belts Check fan belts for excessive wear and cracks and replace them if needed. When replacing a twin type V-belt, replace them both. If only one belt is replaced, it may fail due to the excessive loading. To adjust the fan belts, proceed as fol- lows: a. Loosen mounting cap screw and adjusting nut on the alternator. See Figure 4.38B. b. Loosen or tighten adjusting bolt to adjust fan belt to the specified tension, and tighten mounting nut and adjusting nut properly. See Figure 4.38B. MOUNTING CAPSCREW FIGURE 4.38B NOTE Be very careful when moving the alternator. Do not dam- age the stator coil section located beween the alternator’s front and rear housing.
TIGHTENING TORQUES Mounting cap screw: 8.4 +1.0 Kgf-m (61 +7 lbs-ft) Adjusting nut: 7.7 +1.5 Kgf-m (56 +11 lbs-ft) ALTERNATOR IDLER PULLEY c. After adjustment, start engine and run it at low idle for about 5 minutes. Then recheck belt tension. 2. Air Conditioning Compressor Belt Check belt for excessive wear and cracks and replace if needed. To adjust the AC compressor belt, proceed as follows: a. Loosen the idler pulley nut. See Figure 4.38C. b. Loosen or tighten adjusting bolt. c. Tighten idler pulley nut to 4.0 ~ 5.5 Kgf-m (29 ~ 40 lb-ft) d. After adjustment, start engine and run it at low idle for about 5 minutes with AC turned on. Then recheck belt tension.
ADJUSTING BOLT IDLER PULLEY NUT COMPRESSOR CRANK PULLEY FIGURE 4.38C 4-38 SK210(LC)/SK250(LC)–VI Dynamic Acera OM, 09/00 Rev.2 ALTERNATOR IDLER PULLEY CRANK PULLEY COMPRESSOR BELT DEFLECTION FAN BELT 10 mm ~ 15 mm (0.4"~ 0.6") AIR CONDITIONER 7 mm ~ 10 mm (0.3"~ 0.4") ADJ USTING BOL