Kobelco — C. CHECKING THE RADIATOR CAP & HOSES 4-

MAINTENANCE C. CHECKING THE RADIATOR CAP & HOSES Inspect the radiator cap and hoses every 250 hours of engine operation. 1. Raise the engine cover and make sure to lock it open. See Figure 4.40A. 2. Check the hoses for coolant leakage due to loose clamps, or cracked and worn hoses. 3. Tighten any loose clamps. 4. Should you need to replace any cracked or worn hoses, proceed as follows: WARNING WEAR GOGGLES, SAFETY SHOES, HARD HAT, WORK CLOTHS AND WORK GLOVES TO PERFORM INSPECTION AND MAINTENANCE ON THIS MA- CHINE. WARNING LOCK COVER OPEN USE EXTREME CAUTION WHEN REMOVING THE RADIATOR CAP. THE COOLANT IS UNDER HIGH PRESSURE WHEN HOT. NEVER REMOVE THE RA- DIATOR CAP WHEN THE SYSTEM IS HOT.

ALLOW SUFFICIENT TIME FOR MACHINE TO COOL DOWN . CHECK HOSE CONDITION AND CLAMP TIGHTNESS 4 a. Place a rag or paper towel on the radiator cap and slowly remove it to release the pressure. See Figure 4.40A. b. Locate the radiator lower cover, remove bolts and cover to obtain access to the radiator drain hose and lower hose. See Figure 4.40B c. Place an empty clean container under the ra- diator drain hose. Do not contaminate cool- ant mixture drained, since it can be reused. FIGURE 4.40A NOTE Refer to page 4-11 in regards to proper engine coolant capacity. d. Turn drain valve counter clockwise to drain coolant. See Figure 4.40B. e. Loosen the hose clamp and remove radiator hose. f.

Make sure to clean the areas where the new hose will be connected. g. Remove the clamps from the old hose and install them on the new hose. h. Coat the inside ends of the new radiator hose with grease and install it. Tighten clamps prop- erly. i. Fill radiator with the coolant drained in step c. j. Install radiator cap, start engine, and bring engine temperature to about 90 єC (194 єF). k. Run engine at low idle, check for leakages and repair as needed. l. Install radiator lower cover and close engine cover. 5. Inspect radiator cap for proper operation and re- place if needed. CHECK HOSE CONDITION AND CLAMP TIGHTNESS FIGURE 4.40B 4-40 SK210(LC)/SK250(LC)–VI Dynamic Acera OM, 09/00 Rev.2