MAINTENANCE B. CHANGE OIL IN SWING REDUCTION UNIT Change the swing reduction unit oil on a new ma- chine after the first 500 hours of engine operation then change every 2000 hours. WARNING NEVER CHANGE OILS OR FILTERS ON A MACHINE THAT HAS JUST FINISHED WORKING. ALLOW SUF- FICIENT TIME FOR THE MACHINE TO COOL DOWN BEFORE PERFORMING ANY MAINTENANCE. 1. Move machine to a firm, level surface and place the attachments on the ground. 2. Locate drain port under the center opening of the lower frame. Place a an empty container under drain port and remove plug allowing oil to drain into container. See Figure 4.42B. 4 NOTE Capacity of each swing reduction unit.
SK210(LC)-VI ----------------------- 7.5 Liters (2 Gallons) SK250(LC)-VI, SK250NLC-VI -- 15.3 Liters (4 Gallons) FIGURE 4.42A 3. Clean the drain plug and seal it with teflon tape. Install plug and tighten securely. 4. Remove the oil filler plug and fill with extreme pressure gear oil #90 grade GL-4. 5. Using the dipstick, confirm that the oil level is within the designated range. See Figure 4.42A. 6. Clean the fill plug. Use teflon tape on plug and install. Tighten securely. C. CHECKING AND CLEANING FUEL TANK AND STRAINER SK32004083 DRAIN PORT FIGURE 4.42B 1. Use the ignition key and remove the fuel tank cap. See Figure 4.42C. 2. Check the cap seal and replace it if needed. 3.
Remove the fuel tank strainer and clean it. See Figure 4.42C. Replace the strainer if it is dam- aged. 4. Install fuel tank strainer and use the ignition key to install the cap. FIGURE 4.42C 4-42 SK210(LC)/SK250(LC)–VI Dynamic Acera OM, 09/00 Rev.2 DIP KEEP CLEAN STICK FULL MARK FILL PLUG DIPSTICK SK32004082 DIP STICK