DRAINING V-BELT COVER n Note: If the ATV has been driven through water, the V-belt cover must be drained of any water. 1. Place the ATV on a level sur face. 2. Remove the drain bolt from the cover and allow the water to drain out. 3. Shift the range lever to the neu- tral position; then start the engine. 4. Increase and decrease engine RPM several times to “blow out” any water; then stop the engine. 5. Install the drain bolt and tighten securely. ! WARNING Always use the size and type of tires as specifi ed. Refer to the ap- propriate specifi cations chart for proper tire infl ation pressure, and always maintain proper tire infl ation pressure.
TIRES Tire Tread Condition The use of worn-out tires on an ATV is very dangerous. A tire is considered to be worn out when the depth of the tread is less than 4 mm (5/32 in.). Be sure to replace the tires before rea- ching this minimum specifi cation. GENERAL MAINTENANCE ! WARNING The use of worn-out tires can be dangerous and can increase the risk of an accident. Tire Replacement The ATV has low-pressure tubeless tires. Air is sealed by the contact surfaces of the inner wheel rim and the tire bead. If either the inner wheel rim or tire bead is damaged, air may leak. Be extremely careful not to damage these areas when replacing tires.
It is very important to use the proper tools when repairing or repla- cing tires to prevent damage to the tire bead or wheel rims. If proper tools and related items are not available, have this 83