Arctic Cat GmbH — 400 ENGLISCH

maintenance performed by an authorized Arctic Cat ATV dealer or a qualifi ed tire repair station. ! CAUTION When breaking the tire bead loose from the wheel, be extremely careful not to damage the inner wheel surface or the tire bead. ! WARNING Use only Arctic Cat approved tires when replacing tires. Failure to do so could result in unstable ATV operation. Tubeless Tire Repair Should a leak or fl at tire occur due to a puncture, the tire may be repaired using a plug-type repair. If the damage is from a cut or if the puncture cannot be repaired using a plug, the tire must be replaced.

When operating the ATV in areas where transportation or service fa- cilities are not readily available, it is strongly recommended to carry a plug-type repair kit and a tire pump along. WHEEL REMOVAL 1. Park the ATV on level ground and engage the parking brake lock. 2. Loosen the lug nuts on the wheel to be removed. 3. Elevate the ATV by placing a jack under the axle. 4. Remove the lug nuts. 5. Remove the wheel. 6. Install the wheel and install the lug nuts. 7. Tighten the nuts in a crisscross pattern to 4.4 kg-m (32 ft-lb). ! WARNING Failure to tighten the wheel nuts to the specifi ed torque value can be hazardous.

If the wheel nuts are not properly tightened, the wheel can come off causing an accident and possible injury. 8. Remove the jack. LIGHT BULB REPLACEMENT The wattage rating of each bulb is shown in the chart. When replacing a burned bulb, always use the same wattage rating. 84