Komatsu — CHECK BEFORE STARTING ENGINE, ADJUST

. OPERATION OPERATION USING SEAT BELT WARNING brake pedal fully, and adjust the tether belt (1). Tense tongue (4) connected to wind-in clicks. The belt is pulled (2) until it is fitted to your under this condition and cannot belt to your abdomen without then repeat the above procedure from the start. 3 - 81 Before fastening the seat belt, ins pect the securing brackets and belt fo Replace any worn or damaged se Even if no abnormality can be see n in the belt, replace the seat belt every 3 years. The date of man ufacture of the belt is shown on the back of the belt. fore operating the machine. erating the machine. ithout twisting.

Adjust and fasten the seat belt be Always use the seat belt when op Fit the seat belt across your lap w FASTEN THE BELT AND REMOVE IT 1. 2. 3. 4. 1. Sit on the seat, depress the seat so that your back is pre 2. After adjusting the seat posit the tether belt and install it w seat. Sit on the seat and hold t 3. mechanism (2) and pull out t cover your abdomen sufficie 4. Insert tongue (4) in buckle (3 back into wind-in mechanis abdomen. The belt is locked be extended anymore. Fit th twisting it. REMARK If the belt is locked before the to it 5. 6. 5. Pull the belt to check that it i s securely locked in position. ss the red button on buckle (3). wound in. lts and re-tighten if necessary.

m (2.5 ± 0.5 kgf·m, 18.1 ± 3.6 lbft) 6. When removing the belt, pre The belt will automatically be Check the seat belt mounting bo Tightening torque: 24.5 ± 4.9 N· If the seat belt is scratched or fra yed, if any fittings are broken or deformed from long serv ice, replace the seat belt immediately.