Deutz — 5.2.3 DEFINITION OF TRANSMISSION OPERATING MODES

5. ALARMS 5.2 LIST OF TRANSMISSION CONTROL UNIT ALARMS 5.2.3 DEFINITION OF TRANSMISSION OPERATING MODES When a fault occurs, depending on the severity, the transmission control will respond by selecting one of the following modes: 1 - Limp-Home 2 - Stand-by strategy 3 - Emergency drive 4 - Transmission shutdown 5 - TC-Shutdown Limp-Home In this mode, the operation of the transmission is limited. Whenever Limp-Home mode cuts in, the transmission reverts automatically to neutral and the powershift can no longer be used; the gears must be shifted with the mechanical linkage only.

Forward/reverse direction can be changed only with the tractor at a complete standstill and when the shuttle control lever has been in the neutral position for more than 1 second (or if alarm code 47 is the only one active, simply by depressing the clutch pedal). To bring the transmission out of this mode, the fault must be rectified and the shuttle control lever returned to the “NEU- TRAL” position, or the clutch pedal fully depressed. Stand-by strategy In this operating mode, the transmission management system locks up and the powershift can no longer be used; the gears must be shifted with the mechanical linkage only.

To bring the transmission out of this mode, the fault must be rectified and the shuttle control lever returned to the “NEU- TRAL” position, or the clutch pedal fully depressed. Emergency drive In this mode, the operation of the transmission is limited. Whenever Emergency Drive cuts in, the powershift can no longer be used; the gears must be shifted with the mechanical linkage only. The engagement curve of the main clutch reverts automatically to default parameters. The main clutch can no longer be modulated by way of the clutch pedal (any pressure applied to the pedal will cause the main clutch to engage or disengage completely).

The power supply to the solenoid valves Y1, Y2, Y3, Y4 and Y5 is cut off. Any variation in the signal from the clutch pedal position sensor or the clutch pedal depressed sensor will cause the trans- mission to revert to neutral. The tractor can move off only from a completely motionless standing start, when the shuttle control lever has been in neu- tral position for more than 1 second. To bring the transmission out of this mode, the fault must be rectified and the shuttle control lever returned to the “NEU- TRAL” position. Transmission shutdown In this mode, the operation of the transmission is completely inhibited.

When this shutdown occurs, the transmission locks up completely and reverts to neutral; the power supply to solenoid valves Y6, Y7 and Y8 is cut off. To bring the transmission out of this mode, the fault must be rectified and the shuttle control lever returned to the “NEU- TRAL” position. TC-Shutdown In this mode, the operation of the transmission is completely inhibited. When this shutdown occurs, the transmission locks up completely and reverts to neutral; the power supply to all the pow- ershift solenoid valves is cut off. To bring the transmission out of this mode, the fault must be rectified. 20-83