5. ALARMS 5.2 LIST OF TRANSMISSION CONTROL UNIT ALARMS ALARM N° EE DESCRIPTION The display detects a problem of communication with the transmission control unit. CHECK Connecting a portable computer to the transmission control unit and using the EDS program, check whether or not alarms 19 and/or 20 have been logged, and if so, follow the procedures described for these alarms. Clear all alarms, turn the starter key first to “O” (OFF) and then back to the “I” (ON) position again, and if the alarm is still present, the control unit must be renewed. ALARM GEN1 DESCRIPTION EDS software unable to connect to the transmission control unit.
CHECK Turn the starter key first to “O” (OFF) and then back to the “I” (ON) position, and try connecting to the transmission con- trol unit. Check the integrity of the transmission ECU power supply fuses F27 and F35 With the starter key in the “O” (OFF) position, check that the power input to the control unit is correct (starter key in the “I” (ON) position, 12V measured between pin 23 and pin 68 (positive) and pin 1 and pin 2 (negative) of connector “ECU PS”).
With the starter key in the “I” (ON) position, check that the power input to the control unit is correct (starter key in the “I” (ON) position, 12V measured between pin 21 and pin 45 (positive) and pin 1 and pin 2 (negative) of connector “ECU PS”). With the starter key in the “O” (OFF) position and connector “ECU PS” unplugged, connect a test meter to pin 8 of con- nector “X18” and to cab earth, and measure the resistance to verify whether or not there are short circuits to earth (meter reading: infinity).
With the starter key in the “I” (ON) position and connector “ECU PS” unplugged, connect a test meter to pin 8 of con- nector “X18” and to cab earth, and check that there is no voltage (meter reading 0V). With the starter key in the “O” (OFF) position, connect a test meter to pin 8 of connector “X18” and pin 15 of connector “ECU PS”, and measure the resistance to verify the continuity of the circuit (meter reading: 0 Ohm). If the fault cannot be traced and rectified through this procedure, fit a new control unit. 20-136