5. ALARMS 5.3 LIST OF ALARMS DISPLAYED BY SERDIA SERDIA ALARM N° 67 DESCRIPTION The engine control unit has detected the absence of a connection to the accelerator pedal position sensor or a signal out of range. CHECK Check that the contacts on connector “MX2” of the control unit and connector “X31” are firmly attached and not ox- idised . Check that the resistance characteristics of the accelerator pedal position sensor are correct (for technical details see section 40). Check that the power input to the accelerator pedal position sensor is correct (5 Vdc approx measured between pin 1 (positive) and pin 2 (negative) of connector “X31”).
Check for electrical continuity between pin 4 of connector “X31” and pin 24 of connector “MX2”. With the starter key in the “O” (OFF) position, connect a test meter to pin 4 of connector “X31” and to cab earth, and measure the resistance to ensure there are no short circuits to earth (meter reading: infinity). With connector “MX2” plugged into the engine control unit and the starter key in the “I” (ON) position, connect a test me- ter to pin 4 of connector “X31” and to cab earth, and check that there is no voltage registering (meter reading 0V). 20-155 0.012.8732.4 1 2 14 23 24 25 14 1 2 23 25 24 MX2 GND4 J1 AS6 7 F30 7.5A X31 +15 0441.9533 11 9 10 2 1 4 0.012.8894 D0017161