Deutz — 5.4.4 ANALYSIS OF ALARMS

5. ALARMS 5.4 LIST OF FRONT AXLE SUSPENSION CONTROL VALVE ALARMS ALARM N° 22 LAMP Ind. Disc. DESCRIPTION The control unit has detected that the activation and faults indicator light is burnt out or disconnected. NOTE This alarm is displayed only by the ART. The operator or technician may become aware of the problem simply due to the fact that the lamp does not light up when the front axle suspension is activated. CHECK Check the condition of the indicator lamp. Check that the contacts on connector “5” of the activating switch and connector “JX4” of the control unit are firmly at- tached and not oxidised.

With the starter key in the “I” (ON) position, activate the axle suspension and check that the control unit is supplying power to the indicator light, connecting a test meter to pin 9 and pin 10 of connector “5” (voltage 12V). Check for electrical continuity between pin 10 of connector “5” and pin 8 of connector “JX4”. Check for electrical continuity between pin 9 of connector “5” and the cab earth. If the fault persists, renew the control unit. 20-172 0443.7850 20 5 4 8 12 5 4 20 JX3 12 8 JX4 FE1 5 4 20 12 8 3 8 0.012.8732.4 GND4 J2 AS1 3 8 10 9 AS3 7 F17 7.5A +15 0441.9533 3 21 12 3 5 9 10 1 5 0.012.8894.4 21 12 3 9 10 10 1 D0017250