Deutz — 3.5 ERROR CODE LIST WITH DESCRIPTION

EDS (Electronic Diagnosis System) POWER-SHUTTLE DIAGNOSISPROGRAMM DEST 45 3.5 ERROR CODE LIST WITH DESCRIPTION 20-203 Remarks • Generally upon ”new” electronic system • Self-preservation • Reserve value • Checks or plausibility invalid • Both EEPROM blocks defective no automatic restoration possible • Possible sequence error from: • K+ HK sensor • K+ sensor supply AU1 • Possible sequence error from:

• K+ HK sensor • K+ sensor supply AU1 • Self-preservation • Plausibility circuit • Nhk-SyncN-Nab • Diagnosis only if configured LU can only be diagnosed • Diagnosis only if configured • KM can only be diagnosed in disconnected state •Diagnosis only if configured • KM can only bediagnosed in connected state possible remedy Carry out/repeat HK adjustment Check cabling Check temperature sensor Check sensor supply Check vehicle electr. system voltage Check cabling Check temperature sensor Check sensor supply Check vehicle electr.

system voltage Check cabling Check neutral switch (Start interlock switch) Check speed sensor/cabling Nab, Nhk Check cabling Check lamp in disconnected state Check cabling Check supply warning light Check cabling Check supply warning light System reaction Operation mode NORMAL Default contact pressure Default value: cold (HK pedal holding time, splitter holding time, slip times) No change of operation mode Default value:

cold (HK pedal holding time, splitter holding time, slip times) No change of operation mode No change of operation mode No change of operation mode No change of operation mode No change of operation mode Error location/error cause EEPROM end-of-line data invalid (contact pressure) Temperature sensor LU, K+ Temperature sensor KM Synchronous neutral switch plausibility (Start interlock switch) Warning light LU (Oil pressure/HK overspeed) Warning light KM (Oil pressure/HK overspeed) Warning light K+ (Oil pressure/HK overspeed) Code 11 12 13 14 15 16 17