Deutz — 1.3 SWITCHING ON AND INSTALLING THE SOFTWARE

SERDIA SETUP AND COMMUNICATIONS Starting the next time: SERDIA registers the control units identified the last time the program was started (for example the EMR2). If this control unit is connected the second time the program is started, SERDIA skips the interrogation stage and im- mediately initialises the control unit. This substantially reduces the program startup time. The message "Initialisation is ac- tive!“ appears (and remains for about 7 seconds). Communications are then set up with the control unit. If another control unit is connected the next time the program is started, the interrogation process is performed again (and lasts about 30 seconds).

In engines with two control units (for example an EMR with EMS2), the desired control unit can be selected through another interrogation (see paragraph 2.1). 1.3.7 SETTING UP COMMUNICATIONS WITH THE CONTROL UNIT (ECU) Communications possible: After communications have been successfully set up, the main "Service diagnosis“ screen appears, with the fields "ECU“, "ECU identification“ and "Measured values“ (see Chapter 2, "ECU selection"). This screen contains a menu, and a "Tasks“ switch (see Chapter 8 , " Tasks"). EMR1 EMR2 The communication status between the PC/Notebook and the control unit is indicated by plain text messages, and by a colour code on the status bar: Yellow (flashing):

ISO block processing, i.e. useful data (for example measurements) are being exchanged between SERDIA and the control unit. Green (flashing): ISO connection OK, i.e. only data blocks needed for maintaining communications between SER- DIA and the control unit are exchanged. Red: Communications stopped. Communications not possible: It may not be possible to establish communications for the following reasons: No control unit connected. There is a communication error; see Chapter 9.1.1, "Communication errors". Setting up communications In both cases an error message is displayed, and SERDIA offers to go into Off-line mode; see Chapter, Off-line mode.

1.3.8 OFF-LINE MODE If no control unit/engine and/or interface is available, SERDIA can be run in password-protected mode or Demo mode for training purposes. 20-262