Deutz — 1.4 USING THE PROGRAM

SERDIA SETUP AND COMMUNICATIONS 1.4.1 MAIN SCREEN, MENU SELECTION 20-264 Menu Control units Explanation ECU selection ECU selection all Selecting a control unit (only one can be selected at a time) Print all Print measurements or control unit identification data on a printer or to a file Protocol all Interface configuration (Level IIIa only) Restart all Interrogates control unit again Program ECU EMR2 only Loads operating software into the EMR2 (Level IIIa only) Engine off EMR2 only Remote engine switch-off Reset ECU EMR2 only Resets control unit Measured values actual measured values all Shows current actual values (also with engine off, but with battery voltage)) RAM-Values all EMR1:

Level IIIa only, EMR2:

Level III, IIIa only Data logger EMS2 only Shows content of data logger Input/output assignment all Control unit pin/signal assignments CAN Status all Simple CAN Monitor MVS Measured values MVS only cylinder-specific measurement display Parameters Configuration all To view or modify configuration data Overall programming EMR1, EMR2, EMS2 Level III, IIIa only Calibration Calibration of transducers, for example pedal travel sensors MVS pump class MVS only pump class assignments Error memory Error memory all Reads, displays, and clears the error memory Error memory 2 EMR2 only Reads, displays, and clears the error memory (Level III, IIIa only) MVS error memory MVS only Cylinder-specific error display Function test EMR1, EMR2 To use the actuator control (Level III, IIIa only) Extras Maximum speed EMR1, EMR2 Selection of three different maximum speeds Logistic data al all Load spectrum EMR2, EMS2 Maintenance interval exceeded EMS2 only Override memory EMS2 only Maintenance data Help all General help for main screen and screen buttons.

Tasks EMR1, EMR2 for certain service operations