SERDIA ECU SELECTION 2.4.2 EMR2 IDENTIFICATION DATA MEASUREMENT DATA Meaning of identification data: DEUTZ partNo: Part number of selected control unit. SupplierNo ProductNo: Type of control unit selected: 1 = EMR1 2 = MVS 3 = EMS2 Hardware Rev: Version number of the control unit. Software Rev: numero versione software Number of EEPROM contained in the control unit. If the number before the point has changed (for example, 2.1 to 3.1), the data set will no longer match the control unit. In this case, company head office should be contacted. Binary code checksum ISO Access control Identification data Measurement data Deutz SW-PN:
Part number of EMR2 operating software ECU SerialNo Year ECU SerialNo Month ECU SerialNo Engine number Day, Month, Year of last change: Date at which the control unit parameters were last configured. Lats Service ID: Serial number of interface used for previous access. The first digit indicates authorised access level. Interface serial number: Serial number of interface now being used. Measured values: The "Measured values“ field shows some of the measured values directly. This selection is not configurable. 20-270